Operator`s manual

A-Class 69
Prompts and Condition Messages (continued)
Displayed Message Description Cause(s)
NOT INSTALLED
Indicates the menu item cannot be
enabled.
The option is not installed or cannot
be detected by the printer.
PRINTHEAD CLEANING
Indicates that printhead cleaning is in
progress.
The TEST Key was pressed and
held, or ‘CLEAN HEAD NOW’
was selected.
READY
Normal operating mode. The printer
is ready to receive label formats,
downloads, etc.
The printer is in Ready Mode.
REMOVE RIBBON
PRESS ANY KEY
In order to initiate printhead
cleaning, ribbon must be removed.
The TEST Key was pressed and
held, or ‘CLEAN HEAD NOW’
was selected.
SYSTEM INITIALIZING
Normal power-up and soft reset
condition.
Follows the ‘SYSTEM RESET IN
PROGRESS’ message after a reset
or power-up.
SUCCESSFUL
PRESS ANY KEY
Printhead cleaning was successfully
completed.
The TEST Key was pressed and
held, or ‘CLEAN HEAD NOW’
was selected.
SYSTEM RESET
IN PROGRESS
Normal power-up and soft reset
condition.
The user has reset the printer via the
host or User Interface.
!UNCALIBRATED!
The media calibration must be
performed; see Section 5.1.
The printer is not calibrated.
WAITING FOR DATA
!
A Start of Print signal has been
received.
The printer is waiting for label data
to be supplied by the host.
WAITING FOR SIGNAL!
A label is waiting to be printed.
The printer is waiting for the Start
of Print signal to be supplied by the
applicator.
XXXX OF XXXX PRINTING
!
The print job is being processed.
The printer is updating the batch
status, showing beginning and
remaining label counts.