Operator`s manual

A-Class 35
3.6 Loading Ribbon
To print with thermal transfer media, ribbon is required. The Ribbon Hub configuration will determine
the ribbon type (ink wound ‘in’ or ‘out’) that can be used in the printer. The directional arrows on the
Ribbon Loading Label indicate the way to route the ribbon through the printer.

&
Always use ribbon that is slightly wider than the media (and liner, if any) to protect against printhead wear.
Ribbon types are available with the coated (ink) layer wound ‘in’ or ‘out.’ These are NOT interchangeable
for use with the printer.
Load ribbon into the printer as follows:
1. With the access cover open and the Head Lift Lever raised, position a ribbon to be dispensed in the
direction appropriate for the Ribbon Supply Hub, as indicated in the figures below.
2. Slide a roll of ribbon on the Ribbon Supply Hub until it rests against the hub’s flange.
3. Route the ribbon under the Lower Idler, out the front of the printer, over the Ribbon Shield and Upper
Idler, then up around to the Ribbon Take-Up Hub.
4. Place the ribbon on the Ribbon Supply Hub then turn the hub several times in the direction of take-up
(see arrows on the Ribbon Loading Label) to secure the ribbon.
5. Lower the Head Lift Lever back into the locked position. Close the access cover.
3.6.1 Removing Ribbon
When the ribbon supply is exhausted, grasp the used ribbon on the Ribbon Take-Up Hub, then while
pulling outward, squeeze together the collapsible hub and pull off the ribbon. Next, pull the empty core
from the Ribbon Supply Hub and discard it.