Operator`s manual

34 A-Class
3.5 Adjusting the Media Sensor
The Media Sensor detects labels. Position the Media Sensor as follows:
1. Load media, ensuring that the media is routed through the Media Sensor, as described in Section 3.4.
2. Depending on the type of media being used, rotate the Media Sensor Adjustment Knob until the Eye
Mark on the Media Sensor is positioned according to the table below.
 Note: The printer defaults to the ‘Gap’ Sensor Type for use with die-cut and notched media. If using a different
media, change the Sensor Type. Use your software program, or see Section 4.2.2 for menu details.
Media Sensor Adjustment and Sensor Type Selection
Media Type Eye Mark Position Sensor Type Required
Die-cut Centered over the label Gap
Notched Centered over the notch Gap
Reflective Centered over the black mark Reflective
Continuous Near the middle of the media Continuous *
*
See Section 4.2.2 for the information on the Label Length setting.
Media Sensor
Media Sensor
Adjustment Knob
Eye Mark
Media
Media