Operator`s manual
26 A-Class
The Reset/Test Button is a multi-function switch with the following functions:
(1) When pressed momentarily, this produces a printout of the DMXrfNet Card’s current settings.
(2) When pressed and held for five seconds, this resets the DMXrfNet Card to the factory default
parameters. (The default password is access)
(3) When pressed and held during printer power-up, this causes the DMXrfNet Card to assume Ad-Hoc
mode on WiFi Channel 11 with the Service Set Identifier (SSID) of printer. (This also restores
Console mode.)
3.3.2 Applicator Connections
After setting up the GPIO Port per the instructions found in Appendix D, connect the applicator cable to
the GPIO Port (J2) on the Applicator Interface Card:
WARNING
Failure to properly configure the GPIO Port may result in damage to the printer and / or the
applicator.
Note: Integrators switching from the PE printer, an adapter cable (part number 32-2562-01) is available for the
GPIO Port connection. Pin-out details of this cable are included in Appendix C.