Operator`s manual

146 A-Class
3. Make sure that the printer is turned ‘Off’ and that the AC Power Cord is unplugged. Also, remove
any interface cable(s) attached to the Applicator Interface Card.
Note: Depending upon the configuration of your printer, the location of the Applicator Interface Card can
vary.
4. Remove the two Screws that secure the Applicator Interface Card to the printer.
Applicator Interface Card
Screws
CAUTION
Always wear a wrist strap and follow standard ESD prevention measures when handling the
Applicator Interface Card.
5. Pull out the Applicator Interface Card and place it on a static-free work area.
6. Using the table above and the illustration below, configure the jumpers to meet your system’s
electronic requirements.