Operator`s manual

A-Class 135
Appendix
Module Assignments
Memory Modules
Module Size Volatile
[1]
Location / Total Available / Use
D
1024 KB
(Default size)
Yes
Default, as assigned in System Settings / Default
Module (see Section 4.2.5) or by the <STX>X
command. Main Logic Card DRAM – 1 MB
Configurable. User addressable for graphics, fonts, and
label formats.
512 KB
No
Main Logic Card Flash – User addressable for
graphics, fonts, and label formats.
G
[2]
See Note 3, below.
No
Optional Expanded Flash Main Logic Card User
addressable for graphics, fonts, and label formats.
X
See Note 3, below.
No
Optional Expanded Flash Main Logic Card – 256KB
to 6.5MB size based on ILPC Font purchased. User
addressable for graphics, fonts, and label formats.
Y
128 KB
No
Main Logic Card Flash – reserved for EFIGS
[1]
When power is removed from the printer, stored data will be lost.
[2]
The availability/size of the internal Flash Module is dependent upon the installed Main Logic Card; reference the
Configuration Label, or following the <STX>KC command the “INTERNAL FLASH MODULE PRESENT” message.
The Flash memory has a limited number of writes (approximately 100,000) and is intended for permanent (or semi-
permanent) storage of downloaded images, fonts and label formats.
[3]
Modules G and X are partitioned to equal the sum of the total space available - 6.5MB.