Operator`s manual

100 A-Class
5.4.3 Cleaning the Peel Assembly
Peel Rollers contaminated with grit and label adhesive can reduce the ability of the printer to separate the
labels from the backing material. To prevent problems, clean the rollers as follows:
1. Turn ‘Off’ and unplug the printer. Raise the access cover.
2. Raise the Head Lift Lever. Lower the Peel Assembly Release Lever. Remove media and ribbon.
Peel Assembly
Knurled Roller
Latch Roller
Peel Assembly Release Lever
Head Lift Lever
3. Using a cotton swab dampened with isopropyl alcohol, clean the Latch Roller and the Knurled Roller.
Rotate each roller, wiping and repeating until each entire roller is clean.
4. After allowing the rollers to dry, replace ribbon and media. Close the Peel Assembly and lower the
Head Lift Lever into the locked position.
5. Close the access cover. Plug in and turn ‘On’ the printer. This completes the cleaning procedure.
Feed several labels to normalize media tracking.