Operator`s manual
A-Class 87
5.2.2 Burn Line Adjustment
The printer has been factory-adjusted using 6.5-mil (.0065 inch) media to ensure strict print quality
compliance across most types of label stock. In extreme cases, however, if media of a different thickness
or rigidity is used (for example, heavy tag stock), print quality may be affected. If print quality is not
acceptable, first try the suggestions in Sections 2.2, 2.3, and 5.2.1. If the problem continues, a Burn Line
adjustment may be needed.
&
If you have questions, regarding this procedure contact a qualified technician or Datamax
Technical
Support before proceeding.
Adjust the Burn Line as follows:
1. Load the printer with the media (and ribbon, if required), as described in Section 3.4 (and Section 3.6
for ribbon).
2. Loosen the two Locking Screws on the Printhead Assembly approximately ΒΌ turn counter-clockwise.
Printhead Assembly
Locking Screws
Adjustment Screws