Operator`s manual

20 A-Class Mark II
3. To peel die-cut labels after printing, press down on the Peel Assembly Release Lever to lower
the Peel Assembly; otherwise, proceed directly to Step 6.
Media
Peel Assembly
Release Lever
Peel Assembly
4. Remove the labels from 12 inches (30 cm) of the Media Liner. Route the Media Liner down to
the Peel Assembly, over the Latch Roller, and through the Slot as shown below.
Media
Peel Assembly
Media Liner
Peel Assembly
Latch Roller
Slot