User Manual

www.datamax-oneil.com C-8
In the event of a Wireless LAN communication problem (drop-offs, hangs, can’t communicate, etc.), the
printer can be reset.
To reset the printer:
1) Press and hold the button until the “Radio Off” message is displayed and then release.
2) Next, press and hold the button until the “Turning Radio On” message is displayed and then
release.
The printer will reboot and attempt to connect to the network device using the parameters previously
set in the printer.
As an alternate method, remove the battery from the printer, wait 20 seconds and then reinstall the
battery. See Section 2.1.
The printer is configured with default factory settings. To determine your printer's configuration, print a
Configuration Label (see Section 3.2).
1) Click the Bluetooth
®
menu item in
the Printer Component section of the
configuration utility.
2) To set up the printer for Bluetooth
®
,
change (or confirm) the following
parameter settings:
Bondable: Yes
Connectable: Yes
Discoverable: Yes
PassKey: Default “0000” (must
match entry used on host
computer)
3) After updating the “New Value”
column, click the “Send” button to
send these changes to the printer.
4) Allow 30 seconds for the printer to
reset. For connection to the printer,
please refer to the instructions
included with your Bluetooth
®
adapter or host computer/handheld.