User Manual

www.datamax-oneil.com 28
The printer supports several printer languages, such as CPCL, ZPL, DPL, etc. However, the printer has an
AUTO input mode that will detect the type of script and switch to the desired printing language. By
default, the printer is configured as an AUTO mode. To manually change the printer language used,
perform the following steps.
These setting changes can be performed using the NETira
™
CT Printer Configuration Utility, (see Section
3.4 for more information on NETira
™
CT).
!
The NETira
™
CT Configuration Utility can only communicate to the printer using the DPL printer-
language input mode. If the printer has been set to use an input mode other than DPL, the printer’s
input mode must be changed back to Auto or DPL. This can be performed using the Tools>Set Input
Mode function within NETira
™
CT.
Launch the NETira
™
CT Printer Configuration Utility and query (connect) to the printer.
1) Click on the “Systems Settings”
printer component.
2) Set the ‘Input Mode’ to the
desired emulation under the
“New Value” column.
3) After updating the “New Value”
column, click the “Send” button
to send this change to the
printer.