92-2422-01 Rev.
Overview This document describes the contents, installation, and use of the Peel & Present option for the H-Class printer. After verifying the contents of the kit and the tools needed, follow the steps below to install and begin using the option. A maintenance procedure is also included, so keep this documentation for future reference.
Access Cover C) Raise the Access Cover and remove your media from the printer. Tear Plate D) Remove the Thumbscrew and Tear Plate. (Alternately, if equipped with an Arc Plate, Present Sensor, or Cutter, remove that Thumbscrew device.) Step 2: Installing the Peel & Present Assembly A) Carefully press the Peel & Present Assembly into the Front Plate Connector. Peel & Present Assembly B) Tighten the Mounting Screw to secure the Peel & Present Assembly to the printer.
A) Load Media (see the Operator’s Manual for details). Extend 20 inches (50 cm) of Media Media from the printer. Supply Hub Present Sensor B) Remove the labels from this extended portion of media, leaving only the Backing Material. Backing Material Crease the leading edge of this Backing Material and route it behind the Present Sensor (on the Peel & Present Assembly). C) Route the Backing Material under the Assist Roller and the Internal Rewinder.
F) Ensure that READY is displayed on the Front Panel then press the FEED Key, and proceed according to your observations: Front Panel If REMOVE LABEL is displayed on the Front Panel, this completes the installation; or, If REMOVE LABEL is not displayed on the Front Panel, proceed to Step 4: “Configuring the Printer.
Maintaining the Peel & Present Assembly To ensure trouble free operation, the Peel & Present Assembly should be cleaned after every 100,000 inches (254,000 cm) of media use. This interval depends on the label adhesive, where “gummy” adhesives may require more frequent cleaning. (To easily track label usage, go to SYSTEM SETTINGS MEDIA COUNTERS in the printer’s menu system.) Clean the assembly as follows: 1. Turn ‘Off’ the Power Switch and unplug the power cord from the AC Receptacle.
