92-2468-01 Rev.
Overview This document describes the installation and use of the Internal Rewind option for the H-Class printer. The Internal Rewind option, with an outer diameter capacity of 5.5 inches (140 mm), will hold a partial 8 inch (203 mm) roll of media or, if using Peel and Present, all of the liner material. After taking a moment to verify the contents of the kit and the tools required, follow the steps below to install and use the option.
2) Raise the cover and remove media. Remove the Panel, Thumbscrew and Tear Bar. Tear Bar Note: Alternately, if equipped with a Thumbscrew Cutter or Present Sensor, remove that device. Panel Cover Plate 3) Remove the Cover Screw and then the Cover Plate. Cover Screw Center Plate 4) Mount the Rewinder Assembly (Item ) onto the Center Plate and then secure it using the three Screws (Item ).
Using the Rewinder 1) To wind labels, mount the Arc Plate (Item ) to the Front Housing then secure it using the captivated Screw. Note: Alternately, to peel labels Front Housing reference the instructions for that option. Arc Plate Screw Media 2) Load Media, extending an additional 20 inches (50 cm) and creasing its leading edge. leading edge 3) Route the Media counterclockwise, Media under and around the Rewinder Hub.
Rewinder Hub Slot 4) Insert the creased edge of the Media creased edge into a Slot, and then proceed according to the width: Media Rewinder Hub Slot Full Width Media – Insert the Retainer (Item ) into the creased edge Slot, over the creased edge and around the Rewinder Hub. Begin printing. Retainer Narrow Width Media – Rewinder Hub While holding the creased edge in place, manually rotate the Rewinder Slots Hub counterclockwise several times to secure the Media.
