92-2421-01 Rev.
Overview This document describes the contents, installation, and use of the Cutter option for the H-Class printer. After verifying the contents of the kit and the tools needed, follow the steps below to install and begin using the cutter. A maintenance procedure and a parts list are also included, so keep this documentation for future reference.
B) Press down on the Catch, then pull forward to remove the Door. Catch Door C) Raise the Access Cover and remove your media Access Cover from the printer. Tear Plate D) Remove the Thumbscrew and Tear Plate. (Alternately, if equipped with an Arc Plate, Present Sensor, or Peel and Present option, remove that Thumbscrew device.) Step 2: Installing the Cutter Assembly Carefully press the Cutter into the Front Plate Connector and tighten the Mounting Screw to Cutter secure the Cutter to the printer.
Step 3: Using the Option During operation, cut labels will be dispensed after printing. Begin using the option as follows: A) Load Media (see the Operator’s Manual for details). Then, route the Media out the Cutter Opening. Media B) Plug the power cord into the AC Receptacle and turn ‘On’ the Power Switch.
Step 4: Configuring the Printer While the Cutter option is a plug and play device, this step may be necessary if the printer’s default configuration has been changed. Follow the steps below to configure the printer: Note: In the following procedure, consult the Operator’s Manual for detailed front panel instructions. A) Press the MENU Button on the printer’s front panel. B) Using the DOWN Button, scroll to PRINTER OPTIONS then press the RIGHT Button.
Maintaining the Cutter To ensure trouble free operation, the Cutter should be cleaned after printing each roll or box of labels. Additionally, if the cutting action becomes sluggish, immediate cleaning is recommended. Clean the Cutter as follows: Cutter Blades are SHARP: Keep body parts away from the cutting surfaces. Never use metal objects on the cutting surfaces. Take proper precautions when using isopropyl CAUTION alcohol, a flammable liquid. 1.
4. Close the Cover, then reinstall and tighten the Cover Screw. 5. Carefully press the Cutter Assembly into the Front Plate Connector and, using the Mounting Screw, secure the assembly to the printer. 6. Reload media and close the Access Cover to complete the procedure.
Cutting Requirements Table 1, below, lists the media requirements for use with the cutter option. For a complete listing of media requirements, see the Operator’s Manual. Minimum Description Maximum Inches Millimeters Inches Millimeters 1.0 25 4.
