User's Manual
1/20/2011
3
b) Connect the device’s antenna to the OREO9 via the MMCX connector. Secure the
end cap if used.
3. Configure the mode of operation
a) Select Programs, then Settings, then the Serial Port tab at the bottom of the Settings
screen
b) Select the port labeled OREO9, and select a baud rate of 57.6 KBaud
4. Connect to your wireless device or network
To use the OREO9 to connect to your wireless device, do the following:
a) From the Start menu, select Programs, then select the directory called Datamatic and
run program.
b) When a pop-up screen prompts for a name, enter any alpha-numeric name to
identify this configuration. Also enter the desired synchronization word and radio mode
used by the network or device.
c) Tap the OK button to return to the Config tab
d.) Execute a wake and read command for Star Mode device, or a read device
command for a Mesh Mode device.
Radio Information:
Datamatic declares that the OREO9 (FCC ID: ODYDOREO9) is limited in CH1~CH50
FHSS for 902.5 – 927 MHz ISM operation by specified firmware controlled in U.S.A.
This device is intended for host device integrators only under the following
conditions:
1) The antenna must be installed such that 20 cm is maintained between the antenna
and users, and
2) The transmitter module may not be co-located with any other transmitter or antenna.
IMPORTANT NOTE: In the event that the two conditions above cannot be met (for
example certain device configurations or co-location with another transmitter), then the
FCC authorization is no longer considered valid and the FCC ID cannot be used on the
final product. In these circumstances, the OEM integrator will be responsible for
reevaluating the end product (including the transmitter) and obtaining a separate FCC
authorization.
End Product Labeling
This transmitter module is authorized only for use in device where the antenna may be
installed such that 20 cm may be maintained between the antenna and users, for
example, mobile data terminals (MDTs) and vehicle-mounted devices (VMDs). The final
end product must be labeled in a visible area with the following: “Contains TX FCC ID:
ODYDOREO9”.