User's Manual

1/20/2011
2
Integration Service Personnel: Before you install the module, you require the
following items and information included in this manual.
The Module is installed into a mobile data terminal, vehicle-mounted device, or
other mobile computing device with:
1.) A PCMCIA Type II slot
2.) Approved antenna: Internal antenna, P/N 650019-0001 or antenna end cap, P/N:
CE5B-FLX10, with fitted with MMCX connectors.
3.) Terminal running Microsoft Windows CE Version 4.2 or 5.0
Getting Started:
To complete the setup of your OREO9, perform the following four steps:
1. Install the driver CAB file containing the driver.
2. Install the OREO9 into your host device’s PCMCIA slot
3. Configure the mode of operation
4. Connect to your wireless device or network
Note: It is recommended that you complete the steps in order. If you insert the card in
your device before you install the software, then the “Found New Hardware Wizard”
screen will appear, and you must select “Cancel” to cancel the Hardware Wizard.
1. Install the software
a) Download the appropriate “cab” file for the type of terminal device you are building.
The “cab” file is the software equivalent of a ‘file cabinet’ which contains the driver for the
radio.
b) Copy the file to your device using a supported file transfer mechanism.
Common methods of moving the file include:
- Placing the file on a supported Compact Flash or SD memory card and use that
card for copying the file to the device
- Use a program such as FTP or Microsoft ActiveSync
c) On the device, use the resident File Explorer program to locate the “cab” file
d) Run the “cab” file by double-clicking the file or by right-clicking and selecting “run”
e) If asked to replace any existing files on the device, answer “yes to all”
2. Install the OREO9 into the host device
a) Insert the OREO9 card into the Type II PCMCIA slot