User's Manual

Regulatory Information

United States of America, FCC:

FCC ID: ODYD4300

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions;

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant

to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

--Reorient or relocate the receiving antenna.

--Increase the separation between the equipment and receiver.

--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

--Consult the dealer or an experienced radio/TV technician for help.

Caution: Changes or modifications not expressly approved by the manufacturer could void the user’s authority

to operate the equipment.

To comply with FCC RF exposure requirements, the device and the antenna for this device must be installed to

ensure a minimum separation distance of 20 cm or more from a person's body. Other operating configurations

should be avoided.

Canada, Industry Canada (IC)

The wireless radio of this device complies with RSS 210 Industry Canada. This Class B digital device complies

with Canadian ICES-003. The installer of this radio equipment must ensure that the antenna is located or

pointed such that it does not emit RF field in excess of Health Canada limits for the general population; consult

Safety Code 6, obtainable from Health Canada’s website www.hc-sc.gc.ca/rpb