User Manual

Datamatic, LTD. System Training Manual Version 06.09.09
- 43 -
Confidential Datamatic, Ltd. 2009
It should be noted that when a serial number is supplied, the command is automatically configured for
remote execution.
After the command is entered, press the Blue Key and the ‘E’ key to execute the command. For the
remote execution of the boot images command, after the command is executed, the ‘Command Result’
edit window will show the results of the command as shown in the following dialog:
If the device does not support a command that is executed, the typical response from the device is
‘Command not found: (command)’. The following is an example:
Also, if a terminal command that is needed has not been set up in the list, it can be entered directly in the
Command Line edit control and executed just as if it were in the list.
It should be noted that only a single command can be executed at a time.