User Manual

Datamatic, LTD. System Training Manual Version 08.14.09
- 47 -
Confidential Datamatic, Ltd. 2009
The Command Line edit box shows the formatted command that will be executed on the target device.
When the user selects a command from the drop down list box, the command is automatically formatted
and added to the command line edit box. If the user is executing a command on a remote device (for
example, a FIREFLY), the ‘rexec’ command is automatically added to the command line as shown in
the following dialog:
It should be noted that when a serial number is supplied, the command is automatically configured for
remote execution.
After the command is entered, press the Blue Key and the ‘E’ key to execute the command. For the
remote execution of the boot images command, after the command is executed, the ‘Command Result’
edit window will show the results of the command as shown in the following dialog:
If the device does not support a command that is executed, the typical response from the device is
‘Command not found: (command)’. The following is an example: