User's Manual

©
Datamatic, Ltd. 2007 - 9 -
Wire-end D4100 MOSAIC Installation Supplies
Water Pit Splice Supplies:
Following is a list of materials required to install a wire-end D4100 MOSAIC using the Water Pit
Splice technique:
• Devcon Mark 5 epoxy gun for 50ml cartridge
• Mixing Nozzle for Gun #14285
• UY connectors
 3M IDC Connector-Yellow Part No. 34-7035-9854-9
 3M IDC Connector- Red Part No. 78-8064-7439-7
 AMP Tel-Splice Connector 2 Wire 19-26 AWG-Part No. 1-552795-2
 AMP Tel-Splice Connector 3 Wire 19-26 AWG-Part No. 1-552678-2
• Burial pod
 UY connector/Burial pod combination Connector Kings Corp 800-822-6608.
 3-3M UY Meter Kit SA1013E {3-3M Gels for each plastic pod}
 3M Direct Burial Splice Pod – Part No. 054007-09964 (0110 firmware Wire-end D4100
MOSAIC or higher)
• Devcon Polystrate 2 Ton Epoxy Cartridge #14260
• 2-ton Epoxy Devcon Polystrate 2-ton epoxy 14260 www.devcon.com (to locate a local
distributor.)
• Loctite Quick Set Epoxy gel QM-50 81501 (can locate local distributor.)
 Lowe’s local hardware store www.LOWES.com and go to the “Store Locator” to find a local
store.
NOTE: All supplies for Water Pit Splice method can be purchased from:
Datamatic.com, Ltd. 888-326-5032 or 972-234-5000 www.Datamatic.com
Below are illustrations of materials used with the Water Pit Splice technique: