User's Manual

©
Datamatic, Ltd. 2007 - 15 -
Wire-end D4100 MOSAIC Installation Procedure
Refer to Appendix D & E to determine wire the correct connection for the brand and model of meter.
#1 Set the Reading Mode
• Set D4100 MOSAIC reading mode to Verify Mode.
#2 Wire Connections
Connect the wires with the D4100 MOSAIC and meter using the schematics below:
Schematics: Write in the Wire Color Combinations Below
D4100 MOSAIC
Meter
Schematics: Write in the Wire Color Combinations Below
D4100 MOSAIC
Meter
Connect the wires using UY gel cap connectors. If the wires are stripped, cut off the stripped ends.
Wires must have unstripped ends for use in gel cap connectors. Use the Klein crimping tool to secure the
gel cap connectors.
Below is an illustration of the wires spliced using the UY gel cap connectors:
NOTE: Once connected to the encoded register, test the D4100 MOSAIC connections by programming
the unit and receiving the encoded setup message.
Pulse output registers do not have pre-install test capabilities. Therefore, be sure to have wires
connected properly prior to filling pods with epoxy.
#3 Splice Methods
Water Pit Splice Method using burial pods:
• Fill the burial pod halfway to two-thirds full with epoxy.
• Insert the UY connections into the burial pod so that cables come out of either side.
• Completely fill the empty space left in the pod with approved 2-ton epoxy.
• Tap to make any air bubbles rise to the top.