User's Manual

Chapter 2: FIREFLY Installation 5
©
Datamatic.com, Ltd. 2000 - 2002
Electric FIREFLY Installation
Installation Preparation
Following is a list of hardware needed to install one Electric
FIREFLY
on one meter:
Landis &Gyr ABB
Two 32 x ½ inch long screws Two 0.25 in. spacers
Two .25-inch spacers Two fuse clips – part #3510
Two meter spacer posts Original screws are used
Two fuse clips - part #3510
Sangamo GE
Two 1/8” x ½” long screws Two 4-48x3/8 long screws
Two 0.25 inch spacers Two 0.25 spacers
Two fuse clips – part #3510 Two fuse clips – part #3510
Two Lock Washers
Westinghouse
Two 6-40 x ½” long screws
Two 0.25 inch spacers
Two fuse clips – part #3510
Installing Disk Decals
1. Remove nameplate on meter.
2. Clean rotating disk target area with
99% isopropyl alcohol.
3. Place approved decal* on target
area. Be sure the edge of the decal
is not overhanging on the disk.
4. The user needs to smooth the decal
on the plate by applying pressure
with his/her thumb.
Note: Be sure not to
touch the adhesive side
of the decal as the oil
from the skin can cause
it not to adhere.
*Contact Datamatic for specifications
on approved decals.
(A=58mm, B=24mm)