User manual

2 Sec
1 Sec
Clear Stored Data
Enable Scan & Store
Clear Stored Data
0.5 Sec
0.25 Sec
Transmit Stored Data
CIPHER 1660 BLUETOOTH BARCODE READER OPERATION MENU
Copyright
DaTaMaN Barcode Systems
Set for Remote Data
Collection Mode
Start Instruction Mode
1
2
Update (Exit) Instruction Mode
3
START
(Wait for Red light to blink)
1
Confirm (Wait for response beep)
3
Disable Scan & Store
4
Update (Exit) Instruction Mode
5
2
Steps for Downloading Data to the Server
Begin
Instruction Mode
1
Transmit Delay
2
2
3
Confirm (Wait for response beep)
5
Finish Instruction Mode
6
4
Set for Normal Operation
Clear stored data if
downloading has been
completed successfully.
DaTaMaN Barcode Systems
Tel:- 088 322 7675
Fax:- 088 322 7288
P.O. Box 855
Happy Valley S.A. 5159
www.datamanbarcode.com.au
Note:-
When set for remote data collection mode the
blue flashing light on the USB transponder will
revert to a slow flash, this is normal.
While in remote data collection mode direct
and immediate real time communication with
the server via the transponder will cease.
Proceed to and complete the
Finish Instruction Mode
command to initiate data
downloading to the server.
A delay between each
data record transmission
to the server can be set to
allow adequate time for
data to be processsed.