User manual

Disable Codabar
Disable Interleaved 25
Disable Industrial 25
Save as User Defaults
Capital Lock Auto Detect
Update & Exit Instruction Mode
Validate
Enter Instruction Mode
CIPHER 1660 WIRELESS BARCODE READER SETUP MENU
Copyright
DaTaMaN Barcode Systems
CIPHER 1660 (1)
AUTO POWER OFF (2)
1
Auto - Power OFF
2
Disengage
3
4
Enter Instruction Mode
1
System Default
2
Low Battery Alarm 2.6 V Alkaline
3
Low Battery Alarm 2.6 V NiMh
4
6
7
8
9
Disable ISBN-10 Conversion
10
Update & Exit Instruction Mode
5
Tel:- 088 322 7675
Fax:- 088 322 7288
P.O. Box 855
Happy Valley S.A. 5159
www.datamanbarcode.com.au
DaTaMaN Barcode Systems
NOTE:-
The configuration barcodes in the above column (2) can
beused to instruct the 1660 barcode scanner to disengage
the Auto Power Off mode or set the period to 30 Minutes.
Usage and experience in the field has shown that this Auto
Power Off feature is not always convenient for library
usage. It is however crucial that this sequence of barcodes
are read AFTER reading the barcodes in column (1) and
not before, if this order of reading is not followed it will
result in the shut down period defaulting to 10 minutes.
When scanning the configuration barcodes it may be
necessary to proceed from barcode to barcode slowly to
allow time for each command to be processed internally by
the barcode reader. This requirement is most prominent
when scanning the first and primary barcode in the
column.
Proceeding through the column of barcodes too rapidly
can give erroneous results. Acceptable reading is usually
accompanied by an audible beep or succession of low /
high beeps.
5
6
3
3
3
0
Set for 30 Minutes
Disengage POWER OFF