Quick Reference Guide
Table Of Contents
- Gryphon™ I GBT/GM4500
- Table of Contents
- END USER SOFTWARE LICENSE AGREEMENT
- About the Scanner
- Setting Up the Reader
- Reader, Cradle and LEDs Description
- Connecting the Base Station
- System and Network Layouts
- Using the GBT/GM4500 Scanner
- Using the WLC4090 Radio Base
- Replacing the Battery Pack
- Using the Gryphon™ I GBT/GM4500
- Linking the Reader
- Link Scanner as Serial Device to a Bluetooth Host
- Link Scanner as HID device to a Bluetooth host
- Power Off
- Selecting the Interface Type
- Programming
- Reading Parameters
- Operating Modes
- Technical Features
- LED and Beeper Indications
- Troubleshooting
- Ergonomic Recommendations
- Cleaning Procedure
- Support Through the Website
- Charging the Batteries
- Datalogic Limited Factory Warranty
Charging the Batteries
52 Gryphon™ I GBT/GM4500
The useful life of LI batteries depends on usage and num-
ber of charges, etc., after which they should be removed
from service, especially in mission critical applications. Do
not continue to use a battery showing excessive loss of
capacity, it should be properly recycled / disposed of and
replaced.
Collect and recycle waste batteries separately from the
device to comply with European Directive 2006/66/EC,
2011/65/EU, 2002/96/EC and 2012/19/EU and subse-
quent modifications, US and China regulatory and other
laws and regulations about the environment.
CAUTION
Storage of batteries for long time at fully
charged status or at fully discharged status
should be avoided.
CAUTION
Only in case of long storage, to avoid deep
discharge of the battery it is recommended to
partially recharge the battery every three
months to keep the charge status at a
medium level.
As a reference, run a fast recharge for 20
minutes every three months on unused prod-
ucts to avoid any performance deterioration
of the cell.