Quick Reference Guide

LED and Beeper Indications
Quick Reference Guide 43
LED and Beeper Indications
The imager’s beeper sounds and its illumination flashes or
changes color to indicate various functions or errors on the
reader. A “Green Spot” also lights to indicate a good read.
The tables below list these indications. Reference the PRG
for a more detailed list.
Indication LED Beeper
Power-up
Upper LED flashes/blinks
on power-up, however,
this may be too rapid to
view. With a USB inter-
face, the LED blinks until
enumeration with the
host is completed.
Imager beeps four times
at highest frequency and
volume upon power-up.
Good Read
Upper green LED comes
on for programmed time
(default).
LED behavior for this indi-
cation is configurable
using Aladdin utility.
One beep at current fre-
quency, volume, mono/bi-
tonal setting upon a suc-
cessful label scan. It is
also possible to upload
custom jingles with Alad-
din.
ROM Failure 200ms on / 200ms off
Imager sounds one error
beep at highest volume
for 200 mS.
Limited Scanning
Label Read
N/A
Imager 'chirps' six times at
the highest frequency and
current volume.
Imager Disabled
The LED blinks continu-
ously 100mS on / 900 mS
off
N/A