Quick Reference Guide
Table Of Contents
- Gryphon™ I GBT/GM4500
- Table of Contents
- END USER SOFTWARE LICENSE AGREEMENT
- About the Scanner
- Setting Up the Reader
- Reader, Cradle and LEDs Description
- Connecting the Base Station
- System and Network Layouts
- Using the GBT/GM4500 Scanner
- Using the WLC4090 Radio Base
- Replacing the Battery Pack
- Using the Gryphon™ I GBT/GM4500
- Linking the Reader
- Link Scanner as Serial Device to a Bluetooth Host
- Link Scanner as HID device to a Bluetooth host
- Power Off
- Selecting the Interface Type
- Programming
- Reading Parameters
- Operating Modes
- Technical Features
- LED and Beeper Indications
- Troubleshooting
- Ergonomic Recommendations
- Cleaning Procedure
- Support Through the Website
- Charging the Batteries
- Datalogic Limited Factory Warranty
Operating Modes
Quick Reference Guide 37
Pick Mode
Specifies the ability of the reader to decode labels only when
they are close to the center of the aiming pattern, which is
the area indicated by the red cross. Pick Mode is a Decoding
and Transmission process where bar codes that are not
within the configurable distance from the center of the aim-
ing pattern are not acknowledged or transmitted to the host.
It is active only while the scanner is in Trigger Single mode. If
the scanner switches to a different Read Mode, Pick Mode is
automatically disabled.
Multiple Label Reading
The reader offers a number of options for multiple label read-
ing. See the PRG or software configuration tool for descrip-
tions of these features and programming labels.
NOTE
This feature is not compatible with Multiple
Labels Reading in a Volume. See the PRG for
more information.
PICK MODE
ENTER/EXIT PROGRAMMING MODE
Pick Mode = Disable
Pick Mode = Enable
= default value