Quick Reference Guide
Table Of Contents
- Gryphon™ I GBT/GM4500
- Table of Contents
- END USER SOFTWARE LICENSE AGREEMENT
- About the Scanner
- Setting Up the Reader
- Reader, Cradle and LEDs Description
- Connecting the Base Station
- System and Network Layouts
- Using the GBT/GM4500 Scanner
- Using the WLC4090 Radio Base
- Replacing the Battery Pack
- Using the Gryphon™ I GBT/GM4500
- Linking the Reader
- Link Scanner as Serial Device to a Bluetooth Host
- Link Scanner as HID device to a Bluetooth host
- Power Off
- Selecting the Interface Type
- Programming
- Reading Parameters
- Operating Modes
- Technical Features
- LED and Beeper Indications
- Troubleshooting
- Ergonomic Recommendations
- Cleaning Procedure
- Support Through the Website
- Charging the Batteries
- Datalogic Limited Factory Warranty
Linking the Reader
18 Gryphon™ I GBT/GM4500
Linking the Reader
Link Datalogic Devices to Base
Before configuring the interface it is necessary to link the
handheld with the base.
To link the handheld and the base simply put it into the
base. If the reader was previously linked to another base,
you must first scan the
Unlink
bar code before re-linking to
the new base.
Unlink
Link Scanner as Serial Device to a Bluetooth Host
Use this procedure to let the scanner communicate with a
Bluetooth host using the Bluetooth Serial Port Profile
(SPP).
1. If using a Bluetooth adapter on the host device,
install any driver provided with the adapter.
2. Scan the
Link to Host in SPP mode
label below to make
the scanner visible to the host device.
3. Use the Bluetooth manager of the host device to
“Discover new devices” and select "GBT4500...". If you
receive an error message, it may be necessary to
change the security settings on either the host device
or the scanner.
4. Use an RS-232 terminal program to see incoming
data on the port designated by the Bluetooth man-
ager of the host device.
Link to Host in SPP mode