Quick Reference Guide
Table Of Contents
- Gryphon™ I GBT/GM4500
- Table of Contents
- END USER SOFTWARE LICENSE AGREEMENT
- About the Scanner
- Setting Up the Reader
- Reader, Cradle and LEDs Description
- Connecting the Base Station
- System and Network Layouts
- Using the GBT/GM4500 Scanner
- Using the WLC4090 Radio Base
- Replacing the Battery Pack
- Using the Gryphon™ I GBT/GM4500
- Linking the Reader
- Link Scanner as Serial Device to a Bluetooth Host
- Link Scanner as HID device to a Bluetooth host
- Power Off
- Selecting the Interface Type
- Programming
- Reading Parameters
- Operating Modes
- Technical Features
- LED and Beeper Indications
- Troubleshooting
- Ergonomic Recommendations
- Cleaning Procedure
- Support Through the Website
- Charging the Batteries
- Datalogic Limited Factory Warranty
Connecting the Base Station
Quick Reference Guide 7
Connecting the Base Station
Figure 5 shows how to connect the Base Station to a
terminal, PC or other host device. Turn off the host
before connection and consult the manual for that
equipment (if necessary) before proceeding. Connect
the interface cable before applying power to the Base
Station.
Base Station Connection and Routing —
Fully insert the
Power Cable and Interface (I/F) Cable connectors into
their respective ports in the underside of the Base Sta-
tion. Then connect to an AC Adapter, and plug the AC
power cord into the (wall) outlet.
Figure 5. Connecting the Base Station
The Gryphon GBT/GM4500 can also be Powered
by the Terminal. When powered by the Termi-
nal, the battery charger is automatically set as
Slow charge.
For some specific interfaces or hosts or lengths
of cable, the use of an external power supply is
recommended for full recharging capability
(see
"Technical Specifications" on page 39
for more
details).