User's Manual

M2SD50NBT
Datasheet
 22

13.1.1.1 FCCCaution:
Anychangesormodificationsnotexpresslyapprovedbythepartyresponsibleforcompliancecouldvoidthe
user'sauthoritytooperatethisequipment.
ThisdevicecomplieswithPart15oftheFCCRules.Operationissubjecttothefollowingtwoconditions:(1)This
devicemaynotcauseharmfulinterference,and(2)this
devicemustacceptanyinterferencereceived,including
interferencethatmaycauseundesiredoperation.
13.1.1.2 ImportantNote:
RadiationExposureStatement
ThisequipmentcomplieswithFCCradiationexposurelimitssetforthforanuncontrolledenvironment.This
equipmentshouldbeinstalledandoperatedwithminimumdistance20cmbetweentheradiatorandyourbody.
Thistransmittermustnotbeco‐locatedoroperatinginconjunctionwithanyotherantennaortransmitter.

CountryCodeselectionfeaturetobedisabledforproductsmarketedtotheUS/Canada.
ThisdeviceisintendedonlyforOEMintegratorsunderthefollowingconditions:
1. Theantennamustbeinstalledsuchthat20cmismaintainedbetweentheantennaandusers,and
2. Thetransmittermodulemaynotbe
co‐locatedwithanyothertransmitterorantenna,
3. ForallproductsmarketinUS,OEMhastolimittheoperationchannelsinCH1toCH11for2.4Gbandby
suppliedfirmwareprogrammingtool.OEMshallnotsupp lyanytoolorinfototheend‐userregardingto
RegulatoryDomainchange.

Aslongasthethreeconditionsabovearemet,furthertransmittertestingwillnotberequired.However,the
OEMintegratorisstillresponsiblefortestingtheirend‐productforanyadditionalcompliancerequirements
requiredwiththismoduleinstalled.
13.1.1.3 ImportantNote:
Intheeventthattheseconditionscannotbemet(forexamplecertainlaptopconfigurationsorco‐locationwith
anothertransmitter),thentheFCCauthorizationisnolongerconside redvalidandtheFCCIDcannotbeusedon
thefinalproduct.Inthesecircumstances,theOEMintegratorwillberesponsibleforre
‐evaluatingtheend
product(includingthetransmitter)andobtainingaseparateFCCauthorization.
13.1.2 EndProductLabeling
Thistransmittermoduleisauthorizedonlyforuseindevicewheretheantennamaybeinstalledsuchthat20cm
maybemaintainedbetweentheantennaandusers.Thefinalendproductmustbelabeledinavisibleareawith
thefollowing:ContainsFCCID:U4G‐RHINOIIWEC7.
13.1.3 ManualInformationtotheEndUser
TheOEMintegratorhastobeawarenottoprovideinformationtotheenduserregardinghowtoinstallor
removethisRFmoduleintheuser’smanualoftheendproductwhichintegratesthismodule.
Theendusermanualshallincludeallrequiredregulatoryinformation/warningasshowinthismanual.
13.2 IndustryCanada
13.2.1 IndustryCanadaStatement
ThisdevicecomplieswithIndustryCanada’slicense‐exemptRSSs.Operationissubjecttothefollowingtwo
conditions: