User`s manual

RHINO™

2 INSTALLATION

Rhino™ has been designed to guarantee a fast and easy during mechanical installation.

Rhino™ can be mounted either on the roof, on the floor or on a wall of a fork-lift, in addition,

it can be rotated in order to obtain the best display viewing.

Mounting material:

• Rhino™

• ST-222 Bracket (included in the package)

• 4 to 6 screws, ø = 8mm; since screw length depends on each situation, they cannot be

included in the package. It is recommended to use non-oxidable materials.

• Nuts compatible with the screws of step no. 3

• 8 to 12 washers compatible with the above listed screws. Since screw length depends on

each situation, they cannot be included in the package

• Power supply cable (included)

• Two knobs (included)

• Two plain washers and two notched washers

2.1 INSTALLATION ON FORKLIFT ROOF

Follow these instructions as indicative general guidelines:

1 Find the most suitable place on forklift roof to place Rhino™: it should be as much

protected as possible against water and dust, and it should not obstacle operator's

movements as well.

2 The slots on the bracket will help obtain the best positioning. When working in

environments characterized by strong vibrations, set the screws as next as possible to

bracket's edges.

3 Tighten the ST-222 bracket using the screws and washers. The clamping tooth at the

bottom of ST-222 should be at user's right hand side.

Figure 12 - Screw Positioning

4 Position Rhino™ at the bottom of the bracket: make sure the two large round openings

coincide to the ones located at the edges of Rhino™.