User Manual

Enter/Exit Programming Mode Maxicode
214 QuickScan™ Lite QW2400
Maxicode Length Control
This feature specifies either variable length decoding or fixed length decoding
for this symbology.
Variable Length: For variable length decoding, a minimum and maximum length
may be set.
Fixed Length: For fixed length decoding, two different lengths may be set.
Maxicode Set Length 1
Specifies one of the bar code lengths for Maxicode Length Control on page 214.
Length 1 is the minimum
label length if in Variable Length Mode, or the first
fixed length if in Fixed Length Mode. Characters can be set from 0001 to 0145
characters in increments of 0001 (pad with zeroes).
See page 257 for detailed instructions on setting this feature.
Maxicode Length Control = Variable Length
Maxicode Length Control = Fixed Length
DEFAULT
$CMXLC00(CR)
$CMXLC01(CR)
Select Maxicode Length 1 Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followe
d by the digits from the Alphanumeric char-
acters in
Appendix D, Keypad representing your
desired character(s). End by scanning the ENTER/E
XIT
bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save
the entry string. You can then start again at the
beginning.
CANCEL
$CMXL1
~
0001 = Length 1 is 1 Character
DEFAULT