Specifications

References
246 QuickScan
TM
Lite QW2100
Scan Mode
Selects the scan operating mode for the reader. Selections are:
Trigger Single— When the trigger is pulled, scanning is activated until one of the following
occurs:
-
Scanning Active Time has elapsed
- a label has been read
- the trigger is released
This mode is associated with typical handheld reader operation: when the trigger is pulled, scan-
ning starts and the product scans until the trigger is released, or a label is read, or the maximum
Scanning Active Time has elapsed.
Trigger Hold Multiple — When the trigger is pulled, scanning starts and the product scans until
the trigger is released or
Scanning Active Time has elapsed. Reading a label does not disable
scanning.
Double Read Timeout prevents undesired multiple reads of the same label while in
this mode.
Trigger Pulse Multiple— When the trigger is pulled, continuous scanning is activated until Scan-
ning Active Time
has elapsed or the trigger has been released and pulled again. Double Read
Timeout
prevents undesired multiple reads of the same label while in this mode.
Flashing— The reader flashes
1
on and off regardless of the trigger status. Flash rate is controlled
by
Flash On Time and Flash Off Time. When Flash is ON the reader reads continuously.
When Flash is OFF scanning is deactivated.
Always On— No trigger pull is required to read a bar code. Scanning is continually on. Double
Read Timeout
prevents undesired multiple reads while in this mode.
Autosense
®
Stand Mode— No trigger pull is required to read a bar code. Scanning is turned on
automatically when an item is placed in reader’s field of view. If the trigger is pulled, the reader
acts as if it in single read mode.
Double Read Timeout prevents undesired multiple reads of
the same label while in this mode.
Trigger Object Sense— This mode is similar to Stand Mode, except that a trigger pull is required
to activate the decoder.
1. Controlled by Flash On Time.