Operation Manual

Data Editing

QuickScan

Lite QW2100

ENTER/EXIT PROGRAMMING MODE

Please Keep In Mind...

• Modifying a message string is not a mandatory requirement. Data editing is sophisticated

feature allowing highly customizable output for advanced users. Factory default settings

for data editing is typically set to NONE.

• A prefix or suffix may be applied (reference the Symbologies chapter for these settings)

across all symbologies (set via the Global features in this chapter).

• You can add any character from the ASCII Chart (from 00-FF) on the inside back cover

of this manual as a prefix, suffix or Label ID.

• Enter prefixes and suffixes in the order in which you want them to appear on the output.

Global Prefix/Suffix

Up to 20 ASCII characters may be added as a prefix (in a position before the bar code data) and/

or as a suffix (in a position following the bar code data) as indicated in . See Global Prefix/Suf-

fix on page 260 for more detailed programming instructions.

$CLFPR

Set Global Prefix

$CLFSU

Set Global Suffix

Make a mistake? Scan the CANCEL bar code to abort and not

save the entry string. You can then start again at the beginning.

CANCEL

DEFAULT

No Global Prefix

Global Suffix = 0x0D (CR)