Operation Manual

RS-232 ONLY Interface
40 QuickScan
TM
Lite QW2100
ENTER/EXIT PROGRAMMING MODE
Parity
This feature specifies parity required for sending and receiving data. A parity check bit is the
most significant bit of each ASCII coded character. Select the parity type according to host
device requirements.
• Select None when no parity bit is required.
• Select Odd parity and the parity bit value is set to 0 or 1, based on data, to ensure that an
odd number of 1 bits are contained in the coded character.
• Select Even parity and the parity bit value is set to 0 or 1, based on data, to ensure that an
even number of 1 bits are contained in the coded character.
$CR2PA00
Parity = None
$CR2PA01

Parity = Even
$CR2PA02

Parity = Odd
DEFAULT