Instruction manual

MATRIX 300™ REFERENCE MANUAL

STEP 7 – TEST MODE

Use a code suitable to your application to test the reading performance of the system.

1. Enter the Test function by pressing and holding the X-PRESS™ push button until the

Test LED is on.

2. Release the button to enter the Test function.

Once entered, the Bar Graph on the five LEDs is activated and if the reader starts

reading codes the Bar-Graph shows the Good Read Rate. In case of no read condition,

only the STATUS LED is on and blinks.

Figure 10 – X-PRESS™ Interface: Test Function

3. To exit the Test, press the X-PRESS™ push button once.

NOTE: By default, the Test exits automatically after three minutes.

The Bar Graph has the following meaning:

Figure 11 – Test Function Bar Graph

≥ 95 %

≥ 20 %

≥ 40 %

≥ 60 %

≥ 75 %