User Manual

Product Reference Guide 89
1D SYMBOLOGIES
1D Code Selection
The reader supports the following 1D symbologies (bar code types). See "2D Symbologies"
starting on page 181
for 2D bar codes. Symbology-dependent options are included in each
chapter.
• Disable All Symbologies, page 90 • GS1-128, page 127
• Code EAN/UPC, page 91 • Code ISBT 128, page 128
• UPC-E, page 94 • Interleaved 2 of 5 (I 2 of 5), page 131
• GTIN Formatting, page 97 • Interleaved 2 of 5 CIP HR, page 136
• EAN 13 (Jan 13), page 98 • Follett 2 of 5, page 136
• ISSN, page 100 • Standard 2 of 5, page 137
• EAN 8 (Jan 8), page 101 • Industrial 2 of 5, page 141
• UPC/EAN Global Settings, page 103 • Code IATA, page 145
• Add-Ons, page 105 • Codabar, page 146
• Code 39, page 112 • ABC Codabar, page 152
• Trioptic Code, page 118 • Code 11, page 155
• Code 32 (Ital Pharmaceutical Code), page
118
• GS1 DataBar™ Omnidirectional, page
159
• Code 39 CIP (French Pharmaceutical), page
120
• GS1 DataBar™ Expanded, page 160
• Code 39 Danish PPT, page 120 • GS1 DataBar™ Limited, page 165
• Code 39 LaPoste, page 121 • Code 93, page 166
•
Code 39 PZN, page 121 • MSI, page 171
• Code 128, page 122 • Plessey, page 176
Default settings are indicated at
each feature/option with a green arrow. Also reference
Appendix B, Standard Defaults for a listing of the most widely used
set of standard factory set-
tings. That section also provides space to record any custom settings needed or implemented
for y
our system.
To set most features:
1. Scan the ENTER/EXIT PROGRAMMING bar code at the top of appli
cable programming
pages.
2. Scan the correct bar code to set the desired
programming feature or parameter. You may
need to cover unused bar codes on the page, and possibly the facing page, to ensure that
the reader reads only the bar code you intend to scan.
3. If additional input parame
ters are needed, go to Appendix D, Keypad, and scan the appro-
priate characters from the keypad.
NOTE
Additional information about many features can
be found in the “References” chapter.
If you make a mistake before the last character, sc
an the CANCEL bar code to abort and
not save the entry string. You can then start again at the beginning.
4. Complete the programming sequence by scanning the ENTER/EXIT PROGRAMMING bar
code to exit Programming Mode.