User Manual

Enter/Exit Programming Mode Scanning Features
84 QuickScan™ I QD24XX/QBT24XX/QM24XX
Aiming Duration Timer
Specifies the frame of time the aiming pointer remains on after decoding a label, when in trig-
ger single mode.The range for this setting is from 1 to 255 seconds in 1-second increments.
See page 265 in “References” for a description of this feature.
DEFAULT
LSTM00
Aiming Off After Decoding
LSTM
Set Aiming Duration Timer
To configure, scan the ENTER/EXIT PROGRAMMING
MODE bar code above, then the bar code at left followed
by the digits from the Alphanumeric characters in
Appendix D, Keypad representing your desired
character(s). End by scanning the ENTER/EXIT bar code.
Make a mistake? Scan the CANCEL bar code to abort and
not save
the entry string. You can then start again at the
beginning.
~
CANCEL