User Manual

Enter/Exit Programming Mode

QuickScan™ I QD24XX/QBT24XX/QM24XX

3. If additional input parameters are needed, go to Appendix D, Keypad, and scan the appro-

priate characters from the keypad.

NOTE

Additional information about many features can be found in the “References” chap-

ter.

If you make a mistake before the last character, scan the CANCEL bar code to abort

and not

save the entry string. You can then start again at the beginning.

4. Complete the programming sequence by scanning the ENTER/EXIT PROGRAMMING bar

code to exit Programming Mode.

For more detailed descr

iptions, programming information and examples for setting selected

configuration items, see References, starting on page 239.

NOTE

By default, the handheld will decode bar code labels only when they are close to the

center of the

aiming pattern. This allows the handheld to accurately target labels

when they are placed close together, such as on a pick sheet. See

Pick

Mode, starting on page 80.