User Manual

Technical Specifications
280 QuickScan™ I QD24XX/QBT24XX/QM24XX
LED and Beeper Indications
The reader’s beeper sounds and its LED illuminates to indicate various functions or errors on
the reader. An optional “Green Spot” also performs useful functions. The tables below list these
indications. One exception to the behaviors listed in the tables is that the reader’s functions are
programmable, and may or may not be turned on. For example, certain indications such as the
power-up beep can be disabled using programming bar code labels.
Table 48.
INDICATION DESCRIPTION LED BEEPER
Power-up Beep
The reader is in the process of
poweri
ng-up.
Reader beeps four times at high-
est frequency and volume upon
po
wer-up.
Good Read Beep
A label has been successfully
scan
ned by the reader.
LED behavior for this indi-
cation is configurable via
the feat
ure
Good Read:
When to Indicate
The reader will beep once at cur-
rent frequency, volume, mono/bi-
to
nal setting and duration upon a
successful label scan.
ROM Failure
There is an error in the reader's
software/programm
ing
Flashes
Reader sounds one error beep at
highest volum
e.
Limited Scanning
Label Read
Indicates that a host connection
is not
established when the IBM
or USB interface is enabled.
N/A
Reader 'chirps' six times at the
highest frequency and current
volume.
Reader Active
Mo
de
The reader is active and ready to
scan.
The LED is lit steadily
a
a. Except when in sleep mode or when a Good Read LED Duration other than 00 is selected
N/A
Reader

Disabled
The reader has been disabled by
the
host.
The LED blinks continu-
ously
N/A
Green Spot is on
continuously
While in Stand Mode or Trigger
Stand
Mode the green spot shall
be on while in stand watch state.
N/A N/A
Green Spot
a
flashes momen-
tarily
Upon successful read of a label,
the
software shall turn the green
spot on for the time specified by
the configured value.
N/A N/A
Image Capture When ready to capture image
Blue light flashes 2 times
wh
en updating
N/A
LED and Beeper Indications