User Manual

Setup

18 QuickScan™ I QD24XX/QBT24XX/QM24XX

Interface Selection

Upon completing the physical connection between the reader and its host, proceed to Table 1

starting on page 18 to select the interface type the reader is connected to (for example: RS-

232, Keyboard Wedge, USB, etc.). Scan the appropriate bar code in that section to configure

our system’s correct interface type.

Setting the Interface

Scan the programming bar code from this section which selects the appropriate interface type

matching the system the reader will be connected to. Next, proceed to the corresponding sec-

tion in this manual (also listed in Table 1 on page 18) to configure any desired settings and fea-

tures associated with that interface.

NOTE

Unlike some programming features and options, interface selections require that

you scan only one programming bar code label. DO NOT scan an ENTER/EXIT bar

code prior to scanning an interface selection bar code.

Some interfaces require the scanner to start

in the disabled state when powered up.

If additional scanner configuration is desired while in this state, pull the trigger and

hold it for five seconds. The scanner will change to a state that allows programming

with bar codes.

Table 1. Available Interfaces

RS-232 FEATURES