User Manual

References

258 QuickScan™ I QD24XX/QBT24XX/QM24XX

Label ID: Set Individually Per Symbology

To configure a Label ID individually for a single symbology:

1. Go to page 61 and scan the ENTER/EXIT bar code.

2. Select Label ID position as either BEFORE (Enable as Prefix) or AFTER (Enable as suffix) by

sca

nning the appropriate bar code in the section "Label ID Control" on

page 61. Reference

Figure 12 for Label ID positioning options if multiple identification features are enabled.

3. Scan a bar code to select the symbology for which you wish to configure a custom Label ID

from

the section "Label ID Symbology Selection − 1D Sy

mbologies" on page 62.

4. Determine the desired character(s) (you may choose up to three) which will represent the

Label

ID for the selected symbology.

5. Turn to the ASCII Chart on the inside back cover of this manual and find the equivalent hex

digits associated with your choice of Label ID.

For example, if you wish to select an equal

sign (=) as a Label ID, the chart indicates its associated hex characters as 3D. Turn to

Keypad, starting on page 301 and scan the bar codes represe

nting the hex characters

determined. For the example given, the charact

ers ‘3’ and ‘D’ would be scanned. More

examples of Label ID settings are provided in Table 36.

NOTE

If you make a mistake before the last character, scan

the CANCEL bar code to abort and

not save the entry string. You can then start again at the beginning.

6. Scan the ENTER/EXIT bar code to exit Label ID entry.

7. Scan the ENTER/EXIT bar code once agai

n to exit Programming Mode.

This completes the steps to configure a Label ID for a given symbology.

Figure 12. Label ID Position Options

Prefix SuffixLabel ID Label IDBar Code DataAim ID