User Manual

Setup
10 QuickScan™ I QD24XX/QBT24XX/QM24XX
Installing the Interface Cable
For Corded versions, connect the reader cable by inserting the cable into the handle as shown
in Figure 2. To remove it, insert a paper clip into the release aperture, then unplug the cable.
Figure 2. Connect/disconnect the cable
RS-232 Serial Connection
Turn off power to the terminal/PC and connect the reader to the terminal/PC serial port via the
RS-232 cable as shown in Figure 3. If the terminal will not support
POT (Power Off the Terminal)
to supply reader power, use the approved power supply (A
C Adapter). Plug the AC Adapter bar-
rel connector into the socket on the RS-232 cable connector and the AC Adapter plug into a
standard power outlet.
Figure 3. RS-232 Connection