User Manual

Product Reference Guide 181
2D SYMBOLOGIES
2D Global Features
• 2D Maximum Decoding Time on page 182 • 2D Normal/Inverse Symbol Control on
page 183
• 2D Structured Append on page 183
The reader supports the following 2D symbologies (bar code types). Symbology-dependent
options for each symbology are included in this chapter. See "1D Code Selection" st
arting on
page 89
for configuration of 1D bar codes.
2D Symbologies
• Aztec Code on page 184 • Micro PDF417 on page 199
• China Sensible Code on page 187 • QR Code on page 202
• Data Matrix on page 190 • Micro QR Code on page 205
• Maxicode on page 193 • UCC Composite on page 208
• PDF417 on page 196 • Postal Code Selection on page 210
2D Global Features
The following features are common to all, or in some cases, most of the available 2D symbolo-
gies. Default settings are indicated at each feature/option with a green arrow. Also reference
Appendix B, Standard Defaults for a listing of the most widely used
set of standard factory set-
tings. That section also provides space to record any custom settings needed or implemented
for y
our system.
To set most features:
1. Scan the ENTER/EXIT PROGRAMMING bar code at the top of appli
cable programming
pages.
2. Scan the correct bar code to set the desired
programming feature or parameter. You may
need to cover unused bar codes on the page, and possibly the facing page, to ensure that
the reader reads only the bar code you intend to scan.
3. If additional input parame
ters are needed, go to Appendix D, Keypad, and scan the appro-
priate characters from the keypad.
NOTE
Additional information about many features can be found in the “References”
ch
apter.
If you make a mistake before the last character, scan the CANCEL bar code to
abort and not save the entry
string. You can then start again at the beginning.
Complete the programming sequence by scanning the ENTER/EXIT PROGRAMMING bar code to
exit Programming Mode.