Operation Manual

Configuration Using Code Symbols
48 PowerScan™ M8500
Reading Configuration Barcodes
To configure your reader:
1. Read the instructions for the setting that you want to configure.
1. If needed, go to Appendix F with the hex-numeric table and bookmark it or print it so
you can use i
t during the device configuration.
2. Read the En
t
er Configuration code ONCE, available at the top of each page of con-
figuration.
3. Modify the desired parameters in one or mor
e
sections, following the procedures given
for each group.
4. Read the Exit and S
ave Configuration code ONCE, available at the top of each
page of configuration.
Reference notes providing detailed information for the more complex parameter
s are given
in "References" beginning on page 149.
You must first enable your reader to read barcodes in order to use this
section. If you have not done this, go to
Setup Procedures, starting on
page 33
and complete the appropriate procedure.