Operation Manual

PowerScan M8500 Setup
40 PowerScan™ M8500
For Host Master Network Layouts (see page 37), the network configuration parameters can
be changed through STAR-Link™ software running on the PC. Star-Link™ software can
be downloaded free from the web site: www.scanning.datalogic.com.
For BC-8060 Master Network Layouts (see page 38), the network configuration parameters
ca
n be changed either through the Datalogic Aladdin™ configuration software running on
the PC or by reading the barcode selections in the Network section of this manual starting
on page 79. If using configuration barcodes, it is advised
to completely configure the cradles
before reconfiguring the PowerScan™ M8500 reader (see below).
6.
Read the desired Enable Network code.
END of procedure.
Enable RS-485 Master
Enable RS-485 Slave
After completing the BC-8060 cradle configuration and connections in
the network, you must reconfigure the PowerScan™ M8500 reader using
the STAR-System™ procedure on page 43.