Operation Manual
PowerScan M8500 Setup
38 PowerScan™ M8500
END of procedure.
YOUR READER IS NOW READY TO READ BARCODES.
To change the defaults see "
Configuration Parameters"
on page 47.
6.
Set Radio Address
+
four digits from the Numeric Table in the range 0000-1999.
All readers must have different addresses.
7.
First STAR-System™ Address
Read the code above and the four-digit address of the First STAR-System™ device in
the system.
8.
Set Last STAR-System™ Address
Read the code above and the four-digit address of the Last STAR-System™ device in
the system.
Whenever the system is composed of a single base station, the first and
last base station addresses (steps 7 and 8) must have the same value.
9.
Exit and Save Configuration