Operation Manual

PowerScan M8500 Setup
34 PowerScan™ M8500
If it ever becomes necessary to change the reader, just read the bind-
address label applied to the cradle and position the new reader onto the
cradle.
Do not use multiple readers with this configur
ation method.
Configure the BC-80X0 cradle; refer to the “BC-80X0 Quick Reference Guide”.
END of procedure. YOUR READER IS NOW READY TO READ CODES.
PowerScan™ M8500/BC-80X0 Stand-Alone Setup
Read the restore default parameters code below.
3.
Firmly position the reader onto the cradle within 10 seconds, a beep will be emitted, signaling
that the BC-80X0 cradle has been paired to the PowerScan™ M8500, and the green LED on the
reader will go off.
4.
1. Restore PowerScan™ M8500 Default
Follow the procedure below to set the radio address and bind PowerScan™ M8500 to
the BC-80X0 cradle.
2. Enter Configuration
3. Set Date
+
six digits for Day, Month and Year (DDMMYY)
4. Set Time
+
four digits for Hour and Minutes (HHMM)