Operation Manual

PowerScan™ M8500 Battery Maintenance

Product Reference Guide 27

Wall Mounting

1. Remove the yellow caps and insert the two wall mounting lock hinges provided with

your cradle.

2. Position the cables to be connected to the BC-80X0/C-8000 cradle along the dedi-

cated channels (see figures on

page 26

3. Complete the procedure using one of the following

two methods:

If using the adhesive strips:

• Carefully clean the adhesive strip seats of the base to re

move any impurities that

could reduce adhesion.

• Remove the protective plastic from one side of the adhesive strips and stick them

onto the bas

e surface.

• Remove the plastic from the other side of the strips and affix the base to the wall as

indicated in the

figure below.

If using the mounting screws:

• Using the mounting holes on the base as a pattern, mark the wall where you desire

to mount the BC-8

0/C-8000.

• Drill the appropriate size holes and insert the thr

eaded dowels (not provided) into

the holes.

• Position the base on the wall as indicated in the figure below and affix it by means

of the scre

ws (not provided).