Operation Manual

How to Scan

Quick Reference Guide 13

Variable Length Control, Length One = 1, Length two = 80, Char-

acter Correlation = disabled, Stitching = enabled.

• Interleaved 2 of5—ZeroPattern and Check Character Calcula-

tion = disabled, Check Character Transmission = enabled, Mini-

mum Reads = 1, Decoding Levels and Aggressiveness = 3, Variable

Length Control, Length One = 12, Length Two = 100, Character

Correlation and Stitching = disabled.

Disabled Symbologies

GS1 DataBar (Omnidirectional, Expanded and Limited), GTIN format-

ting, Pharmacode 39, Codabar, Code 93, Code 11, Standard 2 of 5.

How to Scan

When the trigger is pressed, the reader projects a red, horizontal illumi-

nating beam. This beam will remain on until the trigger is released, a

barcode is read, or until a time-out

period expires.

Linear Barcodes —

To scan a linear barcode, center the illumination

beam over the barcode as shown in

Figure 3. The reader must “see” across

the width of all of the bars. Move the reader further away from the bar-

code to increase the scanning coverage area, and closer in to read very

small barcodes.

1. Reference the Product Reference Guide (PRG) for more information about the aiming

beam time-out period.

NOTE

If the surface being scanned is highly reflective

(e.g., laminated), it may be necessary to tilt the item

or the reader slightly (15° to 18°) to prevent

unwanted reflection.